BuckBucker Clamp - Bench-Mounted Humbucker Soldering Jig M50 IT SHOWS HOW THE FOOT

IT SHOWS HOW THE FOOT OF YOUR LASER WILL SIT IN THE BRICK SLOTS

but are just the bottom attachments that get screwed down to your wasteboard

Internal Measurements: 584mm X 584mm X 1352mm

- Air Assist (air hose optional)

BuckBucker Clamp - Bench-Mounted Humbucker Soldering Jig M50 IT SHOWS HOW THE FOOTThe BuckBucker Clamp is a purpose built soldering jig designed to securely hold humbucker pickups during wiring and repair work. It creates a stable, repeatable setup that keeps your pickup in place while freeing up both hands for clean solder joints. Important: This jig must be mounted to at least a board (board not included). If used without a backer, the base can flex and the jig may not work as intended. The BuckBucker Clamp uses a four toggle